Sandwich Panel Roll Forming Device, EPS Sandwich Panel Line, Mineral Wool Sandwich Panel line, Sandwich Panel Roll Forming Line

sandwich panel machine

Sandwich panel production line is specially developed for creating insulation composite board. With stepless speed regulation method, it is in a position to produce corrugated composite panel efficiently at one particular time. Sandwich panel roll forming machine has been an indispensable unit in fabricating roof panels and wall panels in crops and warehouses, among other buildings.

Characteristics

one. The motor energy of the sandwich panel roll forming line is 4kw, and the production speed reaches 6m/min. With the stepless pace regulation method, the effectiveness of the roll forming line is optional within -6m/min.

2. When producing EPS sandwich panel, the pace is typically managed at 2-6 m/min. It will be slightly reduce for producing rock wool board (relies upon on genuine demands)

three. The composite panel generation line is outfitted with K-9 glue metering pump, featuring low rotating speed and high accuracy. The glue is fed at a fee of .one-two. kg/min. It is controlled by frequency converter.

4. The thickness of the composite panel the roll forming device can make is different from 50mm to 250mm. By adjusting the upper and lower rack, and the distance between the cutter holder and the materials feeding rack, we can get sandwich boards with distinct thickness and technical specs.

5. Overall mounted ability: 34KW total fat (like components): seventeen.5t.

6. Dimension of the panel roll forming equipment: 12500 (16000 for rock wool boards) X2200X2800 the roll previous for five variety EPS sandwich panel adopts 23 rubber shafts and 160X80 square tubes with thickness of 6mm the roll former for seven sort composite rock wool panel employs forty five rubber shafts, and upper and lower impartial glue offer. It is geared up with 1.7m rock wool panel conveyor belt, with the diameter of the generate shaft to be 50mm size of the machine frame is up to 9m the roll former is welded with 180X80 sq. tubes which thickness is 8mm.

Requirements for Factories:

The factories exactly where our EPS sandwich panel creation line are utilized can be possibly flatroof or sloped-roof sort. The height of the cornice need to be bigger than 5m, and the efficient width ought to be at minimum 45m. The floor of the factory should be flat and concrete. For basis of the roll forming line, it is needed to be to be 380V, and the total put in electrical power is 34kw. It is essential for the factory to be equipped with .four-.6MPa compressed air supply and illumination gadgets. The roll forming machine shares the very same electricity source with the auxiliary units. The fluctuation of voltage should be no much more than 10%, or it could lead to an abnormal working of the program.

Leave a Reply

Your email address will not be published. Required fields are marked *